Page 1 of 1

IDE Terminal Output Behaviour

Posted: Mon Mar 04, 2019 8:56 pm
by gray
The IDE terminal only shows output, eg. via 'Out.Char()', only after 'Out.Ln'. In comparison, if I connect to the board using PuTTY, each output shows immediately. Is there a way to configure/change this behaviour in Astrobe?

Re: IDE Terminal Output Behaviour

Posted: Tue Mar 05, 2019 10:44 am
by cfbsoftware
No. The Astrobe terminal is intentionally designed to be simple to use and to work 'straight out of the box' without requiring any configuration.

If more configurability / flexibility is required, terminal emulators that I can recommend are FlashMagic, Teraterm and Syscon - whichever is best suited to the task in hand.